Stopping the repository server

This section describes procedures for stopping the repository server.

  1. In the Repository Server Control Panel, if the repository server is running, the status message at lower left reads, The repository server is started, and the Stop button is enabled. Click the Stop button to stop the repository server.

  2. A progress bar appears in the status area with the message, Stopping server. After a few seconds, the progress bar disappears and the message The repository server is stopped appears.


Copyright © 2023 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1(800) 322-0333