Managing automation lab

A Lab Manager session displays and monitors all those TestArchitect controllers that are registered to the session.

One should note that, while a Lab Manager session may monitor any number of controllers, a controller may be registered to only one Lab Manager session at any given time.

Registration may be handled from either end: that is, you may register a controller to a Lab Manager session from within Lab Manager, or self-register the controller, which means, perform the registration from the controller itself.

Lab Manager toolbar
The Lab Manager toolbar consists of several buttons for managing the controllers/devices, test runs, and the display.

Registering controllers
How to register a controller from Lab Manager.

Self-registering a controller
A controller can register itself with a Lab Manager session.

Special note regarding porting virtual machine images
Lab Manager allows for the seamless transport of a cloned controller.

Registering devices
Registering a device from within a Lab Manager session.

Controller status
You can view, within a Lab Manager session, the current status of each registered controller, including the results of test runs (both after-the-fact and in real time) and other information. You can also abort tests on individual controllers, and remove controllers from the session.

Device status
In a Lab Manager session, you can view the current status (in real time or after-the-fact) of each registered device, and mark devices for removal or test termination.


Copyright © 2023 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1(800) 322-0333